How to connect ESP to l alexa



/*

 * If you encounter any issues:

 * - check the readme.md at https://github.com/sinricpro/esp8266-esp32-sdk/blob/master/README.md

 * - ensure all dependent libraries are installed

 *   - see https://github.com/sinricpro/esp8266-esp32-sdk/blob/master/README.md#arduinoide

 *   - see https://github.com/sinricpro/esp8266-esp32-sdk/blob/master/README.md#dependencies

 * - open serial monitor and check whats happening

 * - check full user documentation at https://sinricpro.github.io/esp8266-esp32-sdk

 * - visit https://github.com/sinricpro/esp8266-esp32-sdk/issues and check for existing issues or open a new one

 */


// Uncomment the following line to enable serial debug output

//#define ENABLE_DEBUG


#ifdef ENABLE_DEBUG

       #define DEBUG_ESP_PORT Serial

       #define NODEBUG_WEBSOCKETS

       #define NDEBUG

#endif 


#include <Arduino.h>

#ifdef ESP8266 

       #include <ESP8266WiFi.h>

#endif 

#ifdef ESP32   

       #include <WiFi.h>

#endif


#include "SinricPro.h"

#include "SinricProSwitch.h"


#define WIFI_SSID         "YOUR-WIFI-SSID"    

#define WIFI_PASS         "YOUR-WIFI-PASS"

#define APP_KEY           "YOUR-APP-KEY"      // Should look like "de0bxxxx-1x3x-4x3x-ax2x-5dabxxxxxxxx"

#define APP_SECRET        "YOUR-APP-SECRET"   // Should look like "5f36xxxx-x3x7-4x3x-xexe-e86724a9xxxx-4c4axxxx-3x3x-x5xe-x9x3-333d65xxxxxx"

#define SWITCH_ID         "YOUR-DEVICE-ID"    // Should look like "5dc1564130xxxxxxxxxxxxxx"

#define BAUD_RATE         9600                // Change baudrate to your need


#ifdef ESP8266

#define RELAY_PIN         D5                  // Pin where the relay is connected (D5 = GPIO 14 on ESP8266)

#endif


#ifdef ESP32

#define RELAY_PIN         16                  // Pin where the relay is connected (GPIO 16 on ESP32)

#endif


bool onPowerState(const String &deviceId, bool &state) {

  digitalWrite(RELAY_PIN, state);             // set pin state

  return true;                                // request handled properly

}


void setup() {

  pinMode(RELAY_PIN, OUTPUT);                 // set relay-pin to output mode

  WiFi.begin(WIFI_SSID, WIFI_PASS);           // start wifi


  SinricProSwitch& mySwitch = SinricPro[SWITCH_ID];   // create new switch device

  mySwitch.onPowerState(onPowerState);                // apply onPowerState callback

  SinricPro.begin(APP_KEY, APP_SECRET);               // start SinricPro

}


void loop() {

  SinricPro.handle();                         // handle SinricPro commands

}



Comments

Post a Comment